YI Huchun GE Tingsui (T.S.Ke) Institute of Solid State Physics
,
Academia Sinica
,
Hefei
,
China GE Tingsui
,
Professor
,
Laboratory of Internal Friction and Defects in Solids
,
Institute of Solid State Physics
,
Academia Sinica
,
Hefei
,
China
金属学报(英文版)
Internal friction and elastic modulus of ternary Mn-Cu-Al alloys containing 56—60 wt-% Mn,0-3.59 wt-% Al were measured with acoustic frequency,1 kHz,in the tempera- ture range of-150 to 150℃.It was found that when the specimen was aged in the temperature range under the spinodal curve within the miscibility gap(400—500℃),the internal fric- tion increases with an increase of the aging time and reaches a maximum value at a certain ag- ing time which is shorter with a higher aging temperature.Two internal friction peaks which did not appear before the aging were observed above room temperature after a definite aging time.These are respectively the martensitic tranformation peak and the relaxation peak orig- inating from the stress-induced movement of the twin boundaries.The former peak shifts to- ward higher temperatures with an increase of the aging time,whereas the relaxation peak ap- pearing at 15℃,is independent of the aging time and temperature.The activation energy as- sociated with the relaxation peak was found to be 0.56 eV which is about the same as that of the relaxation peak in binary alloy containing 90 wt-% Mn.It was also found that the hardness,strength and the brittleness of the specimen increase when aged below the spinodal curve within the miscibility gap.The addition or Al enhances the strength but reduces the in- ternal friction of the specimen.A choice of suitable aging time and temperature can give an optimum compromise of high strength and high internal friction.Analysis of experimental re- sults suggests that spinodal decomposition leads to Mn-rich zones in the specimen and thus causes the phase transformation and the change of mechanical properties of the specimen.
关键词:
internal friction
,
null
,
null
,
null
,
null
LIANG Yong LI Ruiguo Institute of Metal Research
,
Academia Sinica
,
Shenyang 110015
,
ChinaInstitute of Corrosion and Protection of Metals
,
Aademia Sinica
,
Shenyang
,
110015
,
China
材料科学技术（英）
Recent advances in laser coating technology including laser cladding,laser surface alloying and laser vapour deposition in China are reviewed in this paper.
关键词:
laser
,
null
,
null
,
null
,
null
Yang LUO
材料科学技术（英）
Due to continued growth in key markets, a broadening of application base and performance improvements, the market demands of NdFeB magnet increased steadily in 1998, and the global output of sintered NdFeB magnet exceeded 10,000 t, in spite of the economic recession in Asia. In 1998 China produced 3,850 t sintered NdFeB block magnet, with an annual growth rate of +22% over the output in 1997.
关键词:
LIU Shuqi
,
YI Tao
,
Peking University
,
Beijing
,
China
金属学报(英文版)
The diagram of Ag-Cu-Ge system was constructed from the investigation of 13 internal sec- tions by DTA heating as well as cooling curves in an atomsphere of dry N_2 . The phase dia- gram is subdivided into two pseudo-ternary systems shown as Ag-Cu-Cu_3Ge and Ag-Cu_3Ge-Ge. Both systems belong to simple eutectic type. The ternary eutectic points lie in." E_1, Ag(22.0)-Cu(58.8)-Ge(19.2), 632℃ and E_2 , Ag(44.3)-Cu(29.5)-Ge(26.2), 533℃. The three side binary systems were redetermined.
关键词:
phase diagram
,
null
,
null
Shaoxiong ZHOU
材料科学技术（英）
The discovery of the first Fe-based ferromagnetic amorphous alloy in 1966 had made an impact on conventional magnetic materials because of its unique properties. Since then, a number of amorphous magnetic materials have been successfully developed and used in a wide variety of applications. A brief review of R & D activities on amorphous soft magnetic materials in China is given from the beginning to the present in a somewhat chronological order, followed by a brief introduction to their applications on electric and electronic industries. An analysis and a prospect of Chinese market of such amorphous materials are also presented.
关键词:
Journal of Alloys and Compounds
Crystal structures of compounds at ambient temperature in the pseudobinary system Gd5Ge4-La5Ge4 were studied by X-ray powder diffraction (XRD). There exist three single-phase regions in this system. The crystal structure of Gd5Ge4, La5Ge4 and Gd3La2Ge4, which are prototype compounds in three phase regions, respectively, were reported. The Gd5Ge4 and La5Ge4 crystallize in the orthorhombic Sm5Ge4-type structure with space group Pnma. The ternary intermediate compound Gd3La2Ge4, which is determined for the first time, crystallizes in the monoclinic Gd5Si2Ge2-type structure with space group P112(1)/a. The Rietveld powder diffraction profile fitting technique was used for the refinement of crystal structure. The lattice parameters, atomic occupations, interatomic distances of the Gd5Ge4, La5Ge4 and Gd3La2Ge4 compounds were derived. (C) 2003 Elsevier B.V. All rights reserved.
关键词:
rare earth compounds;crystal structure;X-ray diffraction;phase-relationships;gd-5(si2ge2);transition;silicon
